Configure network access to the firewall
Configure network access to the firewall
By default, connections to the firewall GUI or console interface are allowed for all addresses.
You can limit the list of addresses from which access will be allowed.
-
Go to Settings → Network → Zones.
-
Click on the name of the Management zone.
-
Open the Access Control tab.
-
Make sure the checkbox in the row of the service you want to configure access to is checked:
- to access the graphical interface — in the Administration Console line;
- to access the console interface — in the CLI over SSH line.
-
In the row of the service you want to configure access to, click Any.
-
Press Add.
-
Enter the IP address from which you will connect to the service, including the subnet mask.
-
Save your changes.